Featherboard cho máy cưa bàn Parkside

I was looking for this part but found nothing compatible with my Parkside tablesaw guide rails (ref PTK 2000 E3), so I quickly designed one.

It should be compatible with other models with same guide rails.

You will need two M5x40 screw and nuts (I only had M5x50 when I took the illustrating picture), plus two large M5 washers.

Please look at the appropriate manual provided with your equipement for all the security warnings relative to tablesaw usage.

I may briefly notice two fondamental points with featherboards usage :

1/Featherboad must be positionned before the rotating blade. Not side by side with the blade, and not after the blade

2/"feathers" must point to the operator's opposite direction

See a quick usage example here : 

Enjoy and please feel free to leave comments and suggestions to improve this model.