
Pi-Powerbutton-skirt-v2.4
- Downloads
- 15
- Likes
- 3
- Views
- 173
- Remixes
- 0
- Comments
- 0
Files 5 671.9 KB
- 250-power_1765622402.3mf3MF · 190.1 KB
- 350-power_1765622403.3mf3MF · 206.1 KB
- 300-power_1765622404.3mf3MF · 200.5 KB
- Power-button-v1_1765622404.3mf3MF · 38.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #80188
- Category
- Ý Tưởng Khác
- Published
- License
- Creative Commons — Attribution
Description
This is a power button addition to a Voron v2.4 skirt.
The schematic to use is shown. The pin 11 = GPIO17 goes via 1K resistor to the LED. The common ground is connected to the pin of the LED and one side of the button to pin 6.
The other side of the button is connected to pin 5 = GPIO3
There need to be 2 lines added to the /boot/config.txt to make this function:
gpio=17=op,dh
dtoverlay=gpio-shutdown
This will make the raspberry pi shutdown safely (wait 5 seconds after the LED goes off) and will turn the LED on or off when the RPI is on or off.
Depending on the button used you may opt for the v1 or v2 button. Just a dot of glue will make either work.
Print spec
- Formats
- 3mf
- Model files
- 5
- Total size
- 671.9 KB
- Largest file
- 206.1 KB


