Khay nhỏ giọt cho bình lọc nước Brita

I made this drip tray because my kids tend to overfill our Brita pitcher just enough that water drips out of the back of the filter reservoir, down the handle, and on to my countertops. Now they can put the pitcher on this drip tray and my counters don't get soaked! I cut up some felt furniture feet and attached them to the bottom but you could leave it flat or use rubber feet.

I have included 3 versions of the drip tray, one with no logo, one with a small Brita logo, and one with a larger Brita logo. The logos make the design look a little more refined and also stop the pitcher from being suctioned to the drip tray by water. I prefer the larger logo for that reason

(In order to print all of the details in the smaller logo version you will need to print with a nozzle smaller than the standard .4mm)

My Print Details:

• Layer Height: 0.2mm
• Nozzle: 0.4mm
• Line Width: 0.6mm (to speed up the print)
• Material: PLA+