Giá đỡ Card PCIe Gridfinity

This model is an extension to Zack Freedman's Gridfinity system. It holds two PCIe cards in upright position. By placing more of them besides each other, you can create a larger array. The 2u-variant is recommended for cards with a 1x connector, the 3u-variant is more suitable for 4x connector cards. However, as the slots are open at the end, so you can put in larger cards, if their center of mass allows for it.

Printing does not require any specific settings, layer heights of 0.2mm or 0.3mm should work fine.

The profiles at the bottom are full-size and do not support screws or magnets. Be aware that some filaments may create issue regarding static discharge.