Khay Xà Bông Dr. Squatch

The perfect tray for Dr. Squatch bar soap.

Included Files:

The tray comes in in two varieties - one that drains collected water and one that does not. In the bottom, a pleasing rhombus design of studs keeps the soap elevated and away from any water, allowing it to harmlessly drain or evaporate.

Print Settings:

• I used .15mm layer thickness, but this is totally up to you and how finely detailed you'd like it
• .4mm nozzle
• 15% infill
• 1.2mm wall thickness
• No supports - you may try some, however, if you are using the version with drains and your printer has trouble bridging the drainage ducts in the bottom of the tray.

This isn't a load bearing part, and so isn't too picky on the details ;)

Use

If you use a shared shower, like in a college dorm, I highly recommend the version without drains - you can just dump any accumulated water out after you shower and walk back to your room without dripping water out of the tray into the hall or your room. Any water that may drip off the of soap will harmlessly evaporate from between the studs.

As for the version with drains, this was designed with storage in the shower or bathtub in mind. The drains will ensure that no water will be left behind.