Chân đế thay thế cho thùng máy Thermaltake Core V21

Replacement snap-in feet for the Thermaltake Core V21 PC case. The original ones just snap off when you try and move your case without lifting it up. I created these to replace them as I couldn't find any existing replacement designs and made them a few mm taller than the original for better clearance. Make sure to either print 4 or sink the model 3 mm below the bed to get the original height :)

Print Settings

Supports: 

No

Resolution:

.2

Infill: 

20

Filament: Generic PLA Black

Notes:

No special settings required :)