Heo Đất Banko

Here is my Banko Piggy Bank. Drop the coin from the top and watch it make saving fun. 

I'm not sure this will print in one piece, it has a .25mm gap. but want you to be able to see it together. The full assembly has a solid bottom if you want to try to print it. 

 For the bottom, there are two options. One has a 10 mm solid bottom. This is to keep it from falling over. Printed at 100 innfill there is more than enough weight to hold it up. The second option has a hollow bottom to be able to fill with something to weigh it down, like sand or washers. This is again in the hopes of keeping it upright. The top for the hollow part should start printing at 10mm. 

Hope y'all like it.