Cáp tín hiệu cho Mitsubishi Outlander Charger

Versions

• M16: For small diameter cables as in the original application this gland is sufficient.
• M20: This is the largest possible option.
• Waipu SP21: If you want to replace the original connector with a 7- or 9-pin Waipu SP21 connector.

Recommended Material & Print Settings

• 0.1mm Layer height for good thread resolution
• The 1.5mm pitch thread can be tight if there is too much extrusion
• The test prints were made with PLA, if you want to use it in a car better use ABS, PETG, …
• The O-Ring groove usually does not need support if you have enough outer perimeters (at least on the layer above the groove) and print them from the inside out.

Additional Hardware

• 1x 22.5x3 or 23x3mm O-Ring
• 1x M16/M20 Cable Gland or Bulgin PX connector as shown in the pictures

For Waipu SP21 only:

• 2x M3 heat set inserts
• 2x M3x8 screws

Please consider liking the model and posting a Make. It took a lot of revisions and a lot of filament to get this right.