Chân đế Ham HT

2020-02-16 Added new version with front stabilizing lip. This should help with front heavy HT's from falling over. Enjoy!

I left the old version in case you like it better. You choose...

This is a HT stand I created over about a year of iterations. I made circles on the bottom for flat rubber feet. I also position one rubber foot to grip the HT clip on the back.(see photo) This made it much easier to adjust a good grip for different radios.

In one case, instead of rubber feet on the base, I epoxied Sonicare toothbrush magnets in place of the rubber feet. After toothbrush needs replacing of course! This stand works great with my ammo-can go-boxes!

73,

WA6ED

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

No

Resolution:

.2

Infill:

50-100%

Filament: Overture PETG Black

Notes:

With my Prusa MK3S, I have successfully printed this stand many times from the bottom. I use PETG with standard PRusa slicer settings. I carefully use a heat gun to remove strings that are common with PETG. Gorilla duct tape works too!

Category: Electronics