Tab thẻ nhớ MicroSD có phần thịt dày hơn

MicroSD_tab_with_etxtra_flesh.stl This is a remix of Zsóka's microSD cards tab where I added more 'flesh' (an extra tab) to glue the microSD card on.  This adds a little extra height, and it could be tight in some SD-card slots.

Print using the concentric pattern for the bottom layer. 

I used a 0.2mm layer height

Some SD-card readers/slots can get very hot, so I don't recommend to print in PLA. I used ABS.

MicroSD_tab_flatprint.stl Here I removed the extra tab as I saw that it was sometimes to tight in some SD-card slots. You can use a piece of tape to add some extra strength.