Nắp Pin Chuột Wifi Seenda

Use whatever settings work for you.  There are a couple different ways of printing this model.

A:  Print in the orientation it prints in.  This require supports but the ugly side is not visible when used. This allows for the exterior features to print nicely.

B:  Rotate the model 180 degrees and lay the flat side on the build plate, NEXT drop the model down below the build plate (On the z axis) exactly .5mm.  This puts the exterior features below the built plate.  The result still require supports but very little but you lose the exterior features.  

The attached picture shows (in cura) what I mean by dropping it below the build plate as well as shows the “exterior features" I have been referencing.