Lâu đài Lọ Lem Disney World

This is a model of Cinderella's Castle from Disney World I made for a flight simulator a while back. Scaled to just under 9 inches tall. Enjoy!

11/08/2023 Update! Fixed an issue with one of the turrets that made printing difficult.  The vertices were not lining up.  Also made the cone on the tree topper version a little taller.

12/9/2022 Update! Added a new version that restores the tunnel to the castle.  Also added a tree-topper version!

6/23/2018 Update! Increased the thickness of crenellations and made a few other edits to the model to make it print better.

6/22/1018 Update! I decided to print this myself and found a couple of issues with the model so I fixed it. The bottom wasn't flat and there was a gap between the main base and the upper tiers of the castle. I printed it a couple of sizes so it should work nicely now.

Print Settings

Printer:

ADIMLabs

Rafts: 

No

Supports:

No

Resolution: 

.2

Infill:

25%

Notes:

Recommend no smaller than 50%. I printed one at 50% and one at 75% and it printed nicely at 75%. Slow it down a little in the slicer so it catches the detail. Took about 8 hours to print at 75% size at half speed.

Also, printed at 100 percent. 0.28 layers 30% cubic infill with 3 gradual steps, and 3 walls and it took 14 hours to print.

Made using AC3D