Hệ thống ống xả lớn từ tính cho Bambu Lab X1 Carbon

See the update below…

This poop chute catches the waste filament as it drops from the Bambu Lab X1 printer.  This is a larger sized container than my other design.

The poop chute uses a two magnets (0.5 inch diameter, 0.10 thick).  The mounting hole for the magnets are cut oversized (0.51 diameter) for an easy fit.  Might need to super glue the magnets in place.

The cutaway o n the size serves two functions.  It gives you a recessed handle to grip the poop chute when taking it off.  The angled top of the cutaway helps direct the waste filament across the chute.  Helps to keep the filament from bunching up directly beneath.

Filament - I used PLA+ or PLA Carbon Fiber

Support - Yes; Hybrid, Auto

Layer - 0.2mm

Infill - 15%

3mf file using Bambu Lab Studio (slicer)

UPDATE:

The design was updated to accommodate the feet added to the X1, X1C, P1P, and P1S.

The new design is poop_shoot_L_magnetic_V2