Máng hứng poop cho Bambu Lab X1C dùng nam châm 3x6mm (KÈM SOURCE)

Differences of the remix compared to the original

I liked V3 Precision's design but I didn’t have the large magnets he used, so I remixed it:

• 4x 3x6mm magnets
• Magnet holes are intentionally tight, you can adjust the fit by cutting a small bit of plastic at the top of the holes.
• Removed the logo for a clean look.
• I've included the Fusion 360 source in case anyone needs to adjust the magnets size or placement.
• I didn't notice there was a v2 that was a bit taller before remixing, but I just added rubber feet after printing. 

Printed in Polylite ASA in 2.5h. Used 117g of filament.

If using ASA/ABS, make sure you use a brim and preheat your chamber to 40C to avoid warping.

Cheers and thank you to the original designer: V3 Precision 

Original Description:

This poop chute catches the waste filament as it drops from the Bambu Lab X1 printer.  This is a larger sized container than my other design.

The poop chute uses a two magnets (0.5 inch diameter, 0.10 thick).  The mounting hole for the magnets are cut oversized (0.51 diameter) for an easy fit.  Might need to super glue the magnets in place.

The cutaway o n the size serves two functions.  It gives you a recessed handle to grip the poop chute when taking it off.  The angled top of the cutaway helps direct the waste filament across the chute.  Helps to keep the filament from bunching up directly beneath.