Chui đèn pin khuếch tán cho Streamlight ProTac 2L-X

Flashlight Diffuser for Streamlight ProTac 2L-X

Settings

• Surface Mode: Surface (no top or bottom) OR Both tip will be printed and the bottom will be open.
• Spiralize Outer contour (vase mode) 
• Layer Height: 0.2
• Wall width: 0.82

With these settings my print was snug on the crown of the flashlight and created a good seal. It “pops” when detaching it from the flashlight. You might need to adjust your wall width depending on your printer to get a good fit.