Khay Đựng Bơ Để Tủ Lạnh

My wife usually keeps several sticks of butter in the refrigerator and she wanted a holder that would keep them neatly organized while taking up minimal room. My first version did not have the dividers so if there were only a couple of sticks in the holder they tended to fall over. This version adds dividers. There are four compartments for full or nearly full lengths of butter. The fifth compartment is a double wide because we noticed when there was only a little bit of butter remaining in a stick it was hard to get hold of. The extra width makes it easy to grab with two fingers.

I printed mine on a MK4 with input shaping enabled with a .4 nozzle using Prusament PETG. This Prusament Chalk Blue is one of my all time faves. I think PLA would be fine for a refrigerator as well but I liked this color.