Chân đế giữ tạ đơn 10kg

This is a simple model designed to prevent dumbbell weights from moving or rolling when placed on a surface. The dumbbells I use are the 10kg set sold by York Fitness in the UK. The holder works for any configuration of the weights. The model will likely work for other 1inch bar plate- based weight systems. The important measurements are below:

For size to see if this will work for your dumbbells- the diameter of the largest (2.5kg) plate is 144mm and the handgrip distance between the two plates is 122mm.

Print 2 side parts and one centre part per dumbbell.

I printed this at 0.28mm layer height and 20% infill with Elegoo PLA+ and have not had any problems with strength.