Skip to main content
F3D
Nắp lưng cho bộ dụng cụ DIY Pikocore 1
Nắp lưng cho bộ dụng cụ DIY Pikocore 1
1 / 3

3 images

DIY

Nắp lưng cho bộ dụng cụ DIY Pikocore

By urbanvanilla

Downloads
40
Likes
5
Views
449
Download all (.zip)· 2 files · 2.1 MB· 2.1 MB

Files 2 2.1 MB

  • PikoecoreBackCover_0.4n_0.2mm_PLA_MK3S_1h3m_1766439268.gcodeGCODE · 2 MB
  • Body2B_1766439267.stlSTL · 88.2 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#6083
Category
DIY
Published

Description

Just put together this DIY kit for Zack Scholl's sweet lo-fi pocket operator cousin. Loved the kit and the device but felt my fingers getting poked by my solder points on the back of the board. Whipped up this quick cover that clips onto the female pins holding the rp2040/pico board at the top. May work on a more elaborate cover that offers more portable protection at a later date. Was quite fiddly getting the tolerances to hold with clips and the board sliding in.

I don't have the non-DIY device but I would assume it won't fit.

Printed with the prongs pointing vertically and on top with support.

Read more Show less

Print spec

Formats
gcodestl
Model files
2
Total size
2.1 MB
Largest file
2 MB

0 comments

See all

F3D uses essential cookies so the site works. Accept all also turns on marketing cookies for traffic and ad measurement; Essential only does not. You can change this in Cookie settings. Read the cookie policy