Bộ chia cho đường chạy bi ZombieHedgehog/Polymaker

A splitter track for the ZombieHedgehog/Polymaker marble run!

This model does not require any fasteners or glue. It is held together by the same magnets that will connect it to the whiteboard.

A splitter track is a fairly common marble run mechanism, but I've designed this from scratch with no references as a design challenge for myself to see if I could figure it out. This is the result.

It's a 3 part marble run track:

• Split Track Body
• Split Track Mechanism
• Split Track Cover

Center of track to the end of the magnet is 15mm.
Includes holes for 10mm x 5mm magnets. (up to 3 magnets per assembly, but you could probably get away with the 2 just in the cover)