Kẹp Giữ Dây Rút Cáp "ZipTie Cable Keeper"

I designed this to help keep the charging cable from my laptop from pulling down on the port and to provide a place to keep the cable so I wouldn't have to go searching for it down beside the couch.  

The cord is fairly heavy for this laptop so I designed this to be sturdy enough to hold it.  I saw commercial versions that would hold it by the end of the cable, but I don't like the idea of putting stress on that part of the cable, so I made this one to attach at the big ferrite choke on this Dell Charger cable.

I created 3 different sizes.  

The size refers to the internal measurement of the holder.

I made it with a wide plate on the bottom and used some double sided tape to secure it to the leg of the table.  Then I added 2 zip ties around that for a more secure fit.  

(This is also why the plate is tapered, so the zip ties can get a good purchase on the cable holder.  

I printed it with Hatchbox PLA on an Elegoo Neptune 2. 

It used about 8 grams of material and took around 35 minutes.

It seems very sturdy, if there any issues I'll update this.

I printed it with the base flat to the build plate and didn't need any supports.

I did specify 2 top skin layers to make a smoother surface.

If you like it let me know!