Bảng đế IKEA Trofast cho bộ chứa Gridfinity

Note: Recently found that some Trofast are a little smaller. Have designed slightly smaller and will print and retest before I post.

Girdfinity baseplates to fit inside IKEA Trofast containers.  I use these with brackets I made as drawers for Kallax storage.

The original baseplates I built from had 6mm models for magnets.  I could not get 6mm magnets in.  So I made plates with 6.1mm and 6.2mm holes for press fit and glue in.  I fine tune with X-Y hole compensation.

Print two of Left and Right to make a full set.  I use 4 screw inserts for each of one side, then bolts from the other side.  So if you insert on the Lefts only, all will work together.  See photos for more info.