
Giá đỡ sơn cho hộp đồ nghề ArtBin Sidekick 8408AB
- Downloads
- 26
- Likes
- 12
- Views
- 455
- Remixes
- 0
- Comments
- 0
Files 4 4.3 MB
- paint_rack_1766288283.scadSCAD · 3 KB
- paint_rack_braces_150mm_1766288284.stlSTL · 1.5 MB
- paint_rack_surface_150mm_1766288285.stlSTL · 1.7 MB
- paint_rack_150mm_1766288286.stlSTL · 1.1 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #57877
- Category
- DIY
- Published
Description
I needed a way to easily remove and replace my paints for storage. This fits the ArtBin Sidekick 8408AB craft box and the SCAD file can be easily tweaked to create any sized rack.
The rack prints in two pieces with divots where the posts should be glued. The best technique is to use a tiny dab of super glue in each divot, then place the rack on top, aligning each foot. Let it cure for a few hours in this position and the rack should be plenty secure for daily use.
If you use multiple layers of these, you'll need a sheet of cardboard (or your brush case, for example) to separate them. They are not naturally stackable.
Print spec
- Formats
- scadstl
- Model files
- 4
- Total size
- 4.3 MB
- Largest file
- 1.7 MB












