Giá đỡ cho bàn game Infinity có bánh xe

These are risers that you provide office chair wheels (11mmx22mm Shaft).  The risers alone raise the table 40mm, or about 1 ½ inches.  With the wheels I used it raises it an additional 60mm, or to a total of about 4 inches.  This is perfect lap height for me.

You will need to remove the small rubber “foot” from the leg corners, and remove the cable clip from the bottom of the one leg (replace screw after removing cable clip).

Supports are needed for the horiz. slot in the base piece.  No other supports needed.

I printed at 0.20 layer height with 4 parameters.  The wheel fits tight but that is what you want.