Skip to main content
F3D
Nắp Lifecounter với ốc vít âm mặt phẳng 1

2 images

Miniatures

Nắp Lifecounter với ốc vít âm mặt phẳng

By landrevj

Downloads
33
Likes
7
Views
192
Comments
1

Files 1 34.8 KB

  • cover-inset_1768146804.3mf3MF · 34.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#53564
Category
Miniatures
Published

Description

This is an alternate version of the cover part from the original make that allows the screws to sit flush with the top of the unit.

In the original make 2x M3x12mm screws are used, however if you are using this part the amount of material the screw is going through is slightly less. I used 10mm screws and it worked fine.

Also, I had some issues with the part warping off the bed near the viewing hole (printing with the flat surface on the part towards the bed). I ended up just increasing the temperature of my bed by a few degrees and that resolved the issue.

Read more Show less

Print spec

Formats
3mf
Model files
1
Total size
34.8 KB
Largest file
34.8 KB

1 comment

See all