Giá đỡ Phaetus Dragon HF cho Stealthburner

Phaetus Dragon HF Mount for Stealthburner

Why not use the P-DRG Mount?

I just finished my v2.4 build, and my set had the HF variant of the Phaetus Dragon included. The obvious goto was to print and use the standard P-DRG mount since it's identical to the HF variant.

Immediately during the first few prints, I clogged the nozzle. Simply because it was impossible to print PLA at under 220°C, which previously was possible (we are talking about the same filament, but a different printer/hotend). But even at 220C, it would occasionally clog the nozzle.

Is the standard P-DRG mount absolutely unusable with the HF Hotend?

If you want to print PLA - I would say, yes, it's unusable.

PETG and ABS work perfectly fine - or at least I have not encountered any problems printing these filaments.

!!! Remember to rerun your Hotend PID Tune !!!