Skip to main content
F3D
Hiệu chuẩn lớp đầu tiên cho đầu phun 0.6mm 1

3 images

Máy In 3D

Hiệu chuẩn lớp đầu tiên cho đầu phun 0.6mm

By Alberta3D

Downloads
116
Likes
10
Views
955
Comments
3

Files 8 10.1 MB

  • 4-point-level-220mm-bed.stlSTL · 337.6 KB
  • 9-point-level-220mm-bed.stlSTL · 759.5 KB
  • 16-point-level-220mm-bed.stlSTL · 1.3 MB
  • 25-point-level-220mm-bed.stlSTL · 2.1 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Hopefully this can help you all get a good first layer, with that bigger nozzle. When you switch to a new nozzle, naturally you're going to want to check you first layer. I've sized this at 0.4 So that you'll be at 2/3  of the Nozzle diameter as this it the recommended maximum. This will give you the most leeway, to play with, in case your bed is way out.

Start with just the 4 Circles, to keep it quick and get you in the ballpark. Then you can move on to the 9 to get it dialed in. If you are using a mesh, I've included a 16 and 25 point to get it truly accurate.

In a perfect world all the Circles will look the same. The goal here is to get the lines of filament, as smooth and gap-less as possible. If your nozzle is too close you'll see the filament getting squished by the nozzle. leaving you with rough topped Circles. If it's too far, then there will be gaps.

Take your time, and start with getting the 4 circles right first. So you're not wasting time and filament.

Don't forget to Like and upload your makes. Let me know what you think, and if any changes need to be made.

Read more Show less

Print spec

Formats
stl
Model files
8
Total size
10.1 MB
Largest file
2.1 MB

3 comments

See all