Giá đỡ bit từ tính Wowstick cho hệ thống Gridfinity

This is a holder for Wowstick bits, meant to fit in to the Gridfinity organization system.

It uses magnets to hold the bits in place, but has material between the bit and the magnet, allowing the magnets to function, but not be so strong that the bits are difficult to quickly pull out.

This is printed as two parts that will needed to be glued together.

Hardware required: 9x 6mm x 2mm magnets

Assembly Instructions:

• Print both pieces
• Insert the 9 magnets in to the holes on the bottom surface
• Glue the bottom surface to the top surface of the Gridfinity bottom.