Giá đỡ bút và dụng cụ văn phòng đa năng

This is a simple desk organiser or organizer for the Americans. It ties a few key designs together along with a spot for my pencil sharpener (The one used in the images was not the original thus the jank mod) a rubber (eraser for the Americans) and a Norris Math set which is a common instrument set here in Australia. This is cut into 2 pieces marked left and right as well as a whole if you have a large enough bed. 
Externally printed parts that make this up are:
Pen Holder originally uploaded @ https://www.crealitycloud.com/model-detail/652e5a6206d6cf3ae6afd1b0
The Micro/SD/USB Rotating Organiser (Organizer) are from  https://www.thingiverse.com/thing:4874570 by Texas_In_FPV with a massive shout out for a favourite design of mine and one of the first things I printed that needed bearings.  These need 2x 608zz each to rotate. (Side note my wife and I constantly refer to these as the USB Darlek’s from Doctor Who.

To glue the 2 halves together in my case as I’ve printed V1.0 I had a soldering iron to make some clearance, so I just did a plastic weld. Otherwise, I would use superglue or another preferred glue option. Printed easily in imported orientation and I’ve done mine in a part roll of PLA and a bit more of another roll in PLA. Printed on the Creality K1 Normal Profile at 3x3 at 10% infill.

Revisions:
V1.0 – Initial Sketch, design and prototype completed, printed as 2 halves, and found some clearances were insufficient.

V1.1 – Added 0.4mm onto 2 of the tight clearances with good results & remodelled the sharpener position around the sharpener I've used.