Giá đỡ tường cho bàn phím Ring Alarm (Gen 2)

This model is a direct replacement for the wall mount that comes with a Ring Alarm Keypad (Gen 2). I created this model so that I could affix the mount using mounting tape on brick without ruining the original piece. I have also use this on another keypad using the original screws and screw locations without any issues (shown in the image where the model is printed in yellow).

This model while not 100% exact to the original, is easy to print and fits the size of the keypad nicely. The model also allows the keypad to friction fit in place like the original. I have yet to have anyone state that it looks in anyway out of place (especially when printed in white).

This model has been tested with both PLA and PETG and the fit is the same between the two assuming you have appropriately created print profiles for you printer and those types of filament.