Bộ chuyển đổi dây đeo cho Hitachi Mini Wand

I designed a top and bottom strap adapter for a Hitachi Wand Mini. It certainly won't fit anything else, but it does fit a Hitachi Wand Mini like a glove. I used M3x12 screws on this, four per strap adapter (top and bottom are 8 total). 1" nylon webbing is used for the straps. I printed this in PLA with 20% infill and didn't run into any problems. I used tree supports on most of it and used support blockers on the "dead end" screw holes on both sides, since those are nice and narrow and not much of a gap to print around.

V2 Update:  I uploaded a V2 of the top and bottom parts that fits the screw heads a little better and uses threaded brass inserts (M3x4x5 or M3x5x5), for an easier time putting them on and taking them off!