Giá đỡ Dremel có khóa an toàn

This version is OLD.

An updated version, can be found here:
https://www.prusaprinters.org/prints/42146-dremel-3000-latched-holder-mk2
The new version has latches on both brackets, fits better and has more sexy looks ;)

Holder designed to fit the Dremel 3000. It will also most likely fit the 4000 without any modification. Designed for quick and easy mounting using latches. No tools or screwing necessary. Both brackets have a very snug fit and hold the Dremel securely in place.

Final assembly requires three M3 screws for each bracket.

Some supports are required when printing. I also recommend printing with a brim, 1 or 2 layers depending on your print settings. Print both brackets as shown in slicer image.

Print instructions

A few supports are needed on a couple of the parts.