Giá đỡ băng đô với thanh mở rộng

My daughter has way more headbands than would fit on the original design.  I modified the rails to be connect so it was longer.

Print 2x side A, 2x side B

• I used supports under the peg just in case, but you probably don't need to

If you want to make it even longer, I would not recommend it as this was already unstable as it is.  You could make a connector piece with holes/pegs on both sides.  However, I used a lot of superglue to get this to hold together.

This was my first remix so it is a little tight of a fit.