
Self centering cylinder / lens holder with stand
- Downloads
- 103
- Likes
- 0
- Views
- 0
- Remixes
- 0
- Comments
- 0
Files 2 4.5 MB
- self centering lens mount assembly.stepSTEP · 1.1 MB
- Lens_self_centering_mount_2026_02_10.3mf3MF · 3.3 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #419515
- Category
- Giáo Dục
- Published
Description
Hi, I made this lens holder mechanism over weekend and would like to share, maybe inspires better things :)
Inspired by commercial self centering lens holders.
Would be great to design print in place flexure based mechanism. Maybe someday I will revisit.
I included .step file in case you want to modify. Use aligned seem in slicer settings, as I added cut to force seem away from sliding surfaces. I printed in PLA and rings might be slightly welded after printing, but should slide nicely once forced with leverage. A little bit of grease helps the mechanism move better.
All rods are press fit, you might start by pressing all 4 required per arm on one arm, then feed through rings and press fit second arm
Enjoy ! :)
BOM:
3 x M3x6
3 x M3x20
3 x tension 15mm long spring, I think I used 0.5mm wire one (o-rings work as well)
3 x 3mm diameter 30mm rod - I recommend 30mm, then you can put lens in from of the gripper, not inside it. 20mm is minimum to join arms
6 x 5mm diameter 20mm rod
For the stand:
6 x M3 insert
3 x M3 thumb screw
Print spec
- Formats
- 3mfstep
- Model files
- 2
- Total size
- 4.5 MB
- Largest file
- 3.3 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-
New -

-

-

-

-

-


