SS American Star ocean liner

Minimum print area height: 25cm Total length after assembly: 63cm

Each STL file specifies the numbers of it needed for the final model (ex: x2, x4, etc)

Recommended print settings:

Layer height: 0.2mm

Perimeter wall count: 3

Lightning infill with 15-20% density

Bottom & Top layers: 5

Elephant foot compensation: 0.1mm, 2 layers

No raft, for smoother bottom surface (where the hull sections meet). Use skirt to prime initial layer flow.

Use snug supports only for the cargo hatches, bridge wings, top deck vents, the wave deflector on the bow, and the "SS America" version of the rear kingpost base.

Use the connector pins and glue to join the hull sections and funnel caps to their bodies.