RAK 1W RUGGED CASE ATAK/MESHCORE

This was heavily inspired from @BerserkerJake_403397 and @Diode663_1505648 rugged Meshtastic/Meshcore case models. The main body in their design was originally centered around a water resistant plug and I find it a bit optimistic in a 3D printed case so I've opted for more commonly available USB-C.

The case is designed to make an easy chassis for a mobile 1W Rakwireless node with GPS and easy USB access for charging. This will work with a base 4631 kit as well.

I have tried multiple iterations of this design and think this is the best so far for someone who wants minimal soldering. With that being said, feel free to make edits.

In my experience, internal GPS puck-antennas works fine in the shell if you opt for that route, but external is cooler....

In the photos I have a ZBM2 Industries filter inline with the lora, I consider it optional.

SMA Connectors:

https://www.amazon.com/dp/B09329TYCS?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

SMA lora antenna(Better quality available if you look around, these are just easy to get fast);

https://www.amazon.com/dp/B0DB5MH38T?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

3700 mAh Battery(always check polarity before using):

https://www.amazon.com/dp/B0F1Y7FFZJ?ref=ppx_yo2ov_dt_b_fed_asin_title

External GPS antenna:

https://www.amazon.com/dp/B0FPKPBW7G?ref=ppx_yo2ov_dt_b_fed_asin_title

USB-C adapter;

https://www.amazon.com/dp/B0CN5TZ8C6?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_9

M3 threaded inserts.

M2.5 threaded inserts.

Assorted M3/M2.5 screws 10-12mm ideal but just get a multipack, you'll end up using them eventually...

Velcro strip for battery if you don't want slop in the case

Print the TPU gasket at %275 scale in the Z axis to start, adjust fit as needed. Gasket is not required.

Special thanks to @oliviawill70 on fiverr for helping make the edits and models!