Modular and scalable stacking drawers

Let me know if you would like more sizes/combinations!

This drawer system is highly customizable and easy to put together. Less than 50g per tier (top uses slightly more filament)! They work great for stickers and office supplies, or anything small you need to organize! They are designed to fit my 4x3 sticker sheets.

Print one top holder, one bottom holder, and as many middle holders as you want per stack. The tiers sit on top of each other with loose pegs and holes, making it easy to rearrange them without having to take anything apart. They do NOT snap together - this eliminates any issues that may arise if your printer is not perfectly calibrated. However, this means that they are not suitable for unsteady areas, like a rolling cart, if they are stacked high.

The holders do not have stoppers to keep the drawers from coming out, so it's easy to take the whole drawer with you instead of having to take out the contents. If you would benefit from stoppers, let me know and I may be able to add them.

These scale very easily. You may need to use some supports on the holder overhangs if you scale them up a LOT, but I haven't needed any at the original size.

Print settings:

• PLA or PETG

• .4mm nozzle

• .25mm layer height (or smaller)

• Brim enabled

• Orient models the same way as in the STLs (holders pointing up, drawer flat on the bed)

• No supports except for underneath the drawer handle

Enjoy!