Skip to main content
F3D
Featherboard PM-1000 1

1 image
DIY

Featherboard PM-1000

By Numb3rEleven

Downloads
136
Likes
25
Views
1,526
Download all (.zip)· 6 files · 15.4 MB· 15.4 MB

Files 6 15.4 MB

  • featherboard_1785844472.stlSTL · 545.1 KB
  • miter_stop_1785844473.stlSTL · 339.8 KB
  • top-spindle_1785844474.stlSTL · 540.8 KB
  • bottom-spindle_1785844475.stlSTL · 702.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#417506
Category
DIY
Published

Description

Featherboard and miter slot clamp for a Powermatic PM-1000 table saw.

The featherboard is designed to go right up to the blade so you can do fairly thin rips on the saw.

Uses 1/4"-20 nuts and bolts. Glue the top and bottom spindle parts together with a nut in the proper place. Place a bolt through the miter stop and put it in the miter slot. Place the featherboard over the bolt and tighten in place.

Should work on a PM-2000 if the miter slot dimensions are the same.

Print is set for 0.30 mm draft, 20% infill, with Prusament PLA. Supports on for overhangs for the bolt head/nuts.

This gives a decent strength/flexability trade-off for the fingers.

Read more Show less

Print spec

Formats
gcodestl
Model files
6
Total size
15.4 MB
Largest file
8.3 MB

0 comments

See all

F3D uses essential cookies so the site works. Accept all also turns on marketing cookies for traffic and ad measurement; Essential only does not. You can change this in Cookie settings. Read the cookie policy