Mô hình Minecraft Blaze - In không cần support

I created the Blaze mob from Minecraft. The prints require no support or color change, and the assembly does not need any screws.

NOTE: This is an unofficial fan-made project and is not affiliated with, endorsed by, or sponsored by Mojang Studios or Microsoft. Minecraft is a trademark of Microsoft.

EDIT:
Adjusted smoke_hat_1, 2, and 4 with a better connection.
I also recommend using PETG as material, as it is more flexible, but PLA has been tested and also works (mixing is also fine).

Recommended colors for the smoke:

version 1 (two color set):

first color (dark):

smoke_base_1,  smoke_middle_1, smoke_top_1, smoke_top_2, smoke_hat_1, smoke_hat_2

second color (light):

smoke_base_2, smoke_middle_2, smoke_top_3 (2pcs), smoke_top_4 (3pcs), smoke_hat_3, smoke_hat_4

version 2 (three color set):

first color (dark):

smoke_top_2

second color (medium dark):

smoke_base_1, smoke_middle_1, smoke_top_1, smoke_top_4 (1pcs), smoke_hat_1, smoke_hat_2

third color (light):

smoke_base_2, smoke_middle_2, smoke_top_3 (2pcs), smoke_top_4 (2pcs), smoke_hat_3, smoke_hat_4

Recommended color for the legs and head:

For the prints in the image, I used three colors, which I divided into the coloring as follows: 
'Bottom_____' first color
'Middle_____' second color
'Top____' third color