Vỏ case cho Radxa Zero 3W kèm quạt 4010

By mthqwork_615457

Downloads: 6
Likes: 0
Views: 75
Remixes: 0
Comments: 0

Download all (.zip)· 10 files · 2.5 MB· 2.5 MB

Files 10 2.5 MB

radxa_zero3w_case_v3_1785755546.scadSCAD · 10 KB
radxa_zero3w_case_v4_1785755548.scadSCAD · 10.1 KB
radxa_zero3w_case_v5_microSD_1785755549.scadSCAD · 11 KB
Lid_1785755550.stlSTL · 723.9 KB
Lid_15_1785755551.stlSTL · 228.6 KB
Base_v5_microSD_1785755552.stlSTL · 230.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID: #417100
Category: Dụng Cụ Tiện Ích
Published: 08/03/2026
License: Creative Commons — Attribution
Tags: radxa
zero3w

Description

IMPORTANT!

If you have a non-eMMC model variant or going to use the microSD slot you MUST use V5 as earlier versions does NOT have hole for the microSD and will be unusable!

A two-piece, snap-fit printed enclosure for the Radxa Zero 3W with a 40 × 40 × 10 mm fan mounted inside, blowing straight down onto the SoC. No visible screws on the outside except the four countersunk fan screws, and no fan hanging off the side of the case.

**Printing:
**I have used PETG but PLA should be OK as well.
Print the stuff facing down. Supports are needed.

What you need:
1 x 4010 Fan
4 x M3x6 for the board
4 x M3x16 for the fan + washers optionally

The tray bosses are drilled 2.5 mm and are meant for thread-forming screws directly into plastic, no heat-set inserts.

Source
Board geometry from Radxa's official 3D model, radxa_zero_3w_3d.stp, available from the Radxa documentation download page. The SCAD file carries the measured values inline so you don't need the STEP to modify it.

Tools
AI help was used.

What's new in v4:
- Added toggle to turn off bottom vents
- Fan thickness is set to 15mm default to make it compatible with more fans (like Noctua NF-A4x10)

What's new in v5:
- Added hole for the microSD, so it's not only for the eMMC model anymore.