Chân đế thay thế cho camera Wyze OG

Replace your original Wyze OG camera mount with this simple, sturdy 3D-printable alternative.

Designed as a direct replacement for the factory mount, this bracket securely holds your Wyze OG Camera while allowing easy wall or ceiling installation (choose screw mount version). It is ideal if your original mount is broken (like mine), lost, or if you simply need an extra mounting location.

Features

• Direct replacement for the original Wyze OG mount (a little taller)

• Strong and lightweight design

• Easy to print

• Uses the original camera attachment

• Suitable for wall or ceiling mounting

• Clean, minimal appearance

• 2 models: with or without screws holes

• Fusion files included if you need modifications

Printing Recommendations

• Material: PETG or ASA (recommended for indoor and outdoor use)

• PLA is suitable for indoor installations.

• Layer height: 0.20 mm

• Walls: 3–4

• Infill: 20–30%

• Supports: Not required

Installation

Push the original ball pivot with screw into the bottom hole to the top and re-attach the camera. You may need a pencil like tool to push it all the way up.

The clearance should be enough to keep the ball from slipping. If not, tolerances might need to be adjusted on your printer or in the design to compensate the differences between printers.

Simply print the mount, attach it to the wall or ceiling using appropriate screws, and screw your Wyze OG camera into place just like the original mount.