Umoya SBCAR dành cho Lynx

This is the same Umoya posted by WaFfLe and ZafC with the threaded collet removed and replaced with a 3rd o-ring.  Made this to fit a Lynx with an 18" barrel where there isn't enough barrel to use a collet.  This will slip inside the shroud of the lynx.  It requires a 3rd o-ring for alignment and stabilization.  There are vent holes between the the o-rings to prevent air pockets and allow for maximum grip.  (Possibly unecessary)

Print as oriented, with tree supports under the long bridges only for better quality, can be printed without supports as well.