Bộ dẫn hướng ống PTFE cho Creality K2 Pro

PLEASE NOTE THIS MODEL IS STILL IN TESTING PHASES

This model has been stress tested for 20 hours on the K2 Pro w/o any issue!

In working with my K2 Pro, I was trying to find a solid model to help keep the PTFE tube off the top of the glass lid. This model is my take on the solution. It fits through the cable chain to guide the tube enough to keep it off of the glass lid. What's even better is that you do not have to remove the glass top and disconnect the PTFE tubing. The clip guide slides on and good to go. Can't get any easier than that! 

I used PETG but would recommend ASA.

 If you print this model and utilize it, please let me know what you think! I know it works with the K2 Pro. I'm not sure if it would work on any of the other K Series printers.

Let me know what your thoughts are! Thanks for looking!