
Đế chuyển đổi Anker Prime MagSafe sang chuẩn AMPS
- Downloads
- 1
- Likes
- 1
- Views
- 41
- Remixes
- 0
- Comments
- 0
Files 2 333.1 KB
- anker_amps_mount_1784359122.stepSTEP · 78.8 KB
- anker_amps_mount_1784359123.stlSTL · 254.3 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #413167
- Category
- DIY
- Published
- License
- GNU General Public License v2.0
Description
Simple adapter plate for Anker's Prime MagSafe Car Charger, to allow it to be mounted to AMPS-pattern receivers (holes arranged in a rectangle 30mm x 38mm center-to-center). Requires (almost) non-destructive disassembly of the car charger. Reuses the existing screws in the car charger, so no additional hardware needed.
Originally printed in Siraya Tech ABS-GF (pictured). ABS recommended for car usage (cars get hot in the sun) but should work fine in PETG or PLA as well given the low mechanical stress.
Detailed instructions for charger disassembly (not mine) can be found at https://www.reddit.com/r/anker/s/UMqLCC8uln
Anker Prime MagSafe Car Charger: https://www.amazon.com/dp/B0F48CYG21
Note: The holes were sized empirically (printed a few times until I got things to fit right) so results may vary, STEP files are provided so you can adjust the hole sizes yourself as needed.
Print spec
- Formats
- stepstl
- Model files
- 2
- Total size
- 333.1 KB
- Largest file
- 254.3 KB












