Ngàm gắn núm khóa Midlock cho Xshot Thrasher

Overview

This is a bracket to secure the midlock attachment knobs designed by Chance to an Xshot Thrasher. It uses 4x m3 heat set inserts (5mm x 6mm) and 4x m3 screws. I'm using m3 screws because it's what I had on hand and they work with the knobs if you use a washer. You will need to cut away some plastic from the inside of the Thrasher shell to make room for the screw heads as seen in the pictures. If done correctly this will not interfere with anything. Note that due to the placement of the bracket, the knobs stick out a fair bit. I have found though that they do not get in the way and put the blaster in a good spot so you can hit the release lever on the midlock holster with your thumb. 

Printing Info 

• 80% infill, 4x walls, gyroid. 

• Use Pteg, ABS, or Pla.

• Print with the part on its side. No supports are required.  

• The file for the knob can be found on Chance's page.