
Nắp đậy chống bụi cho nến Diptyque 190g
- Downloads
- 1
- Likes
- 0
- Views
- 22
- Remixes
- 0
- Comments
- 0
Files 1 110.8 KB
- candle_cover_1784113645.stlSTL · 110.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #412082
- Category
- Đồ Gia Dụng
- Published
- License
- Creative Commons — Attribution
Description
This is a simple protective cap designed to keep dust out of a Diptyque 190g candle between uses. It's a two-part shape in one print: a flat cap that rests on top of the candle's rim, with a small plug underneath that inserts into the opening to keep the cover centered and in place.
Fit
Designed for the standard Diptyque 190g jar (77.5mm outer rim diameter, 3mm rim wall). The plug is sized with a 0.3mm diametral clearance for a snug but removable fit on a well-calibrated printer. If your rim diameter differs slightly, scale the model or adjust the plug diameter accordingly, the fit is tight enough that small tolerance shifts matter more than for most prints.
Print settings
-
Layer height: 0.2mm
-
Infill: 15-20%
-
Supports: none needed
-
Orientation: print flat, cap facing down (as designed)
-
No specific material requirement - PLA is fine for this indoor, low-stress application
Notes
The plug has a 1mm chamfer on its lower edge to ease insertion. If the fit feels too tight, a light sand of the plug's outer edge will loosen it without needing a reprint.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 110.8 KB
- Largest file
- 110.8 KB
0 comments
You may also like 12 models
See all-
New -
New -

-
New -

-

-

-

-

-
New -
New -


