Skip to main content
F3D
Móc treo nón bảo hiểm gắn tường 1

3 images

Đồ Gia Dụng

Móc treo nón bảo hiểm gắn tường

By kennyd1gital

Downloads
8
Likes
4
Views
51

Files 2 881.3 KB

  • HelmetHook_1784108421.3mf3MF · 277.2 KB
  • HelmetHook_0.4n_0.2mm_PETG_COREONE_34m_1784108422.bgcodeBGCODE · 604.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

A simple wall-mounted hook for hanging a helmet. This hook was specifically designed for a Triple Eight Gotham MIPS helmet (the adjuster mechanism at the rear of the helmet sits perfectly in the hook), but it will work with any helmet by looping a strap over the hook.

Print Recommendations

  • 0.4mm nozzle, 0.2mm layer height.

  • 3 perimeters.

  • 15% cubic infill.

Required Hardware

  • 1x – #8 (or M4) wood screw of sufficient length for your specific installation

    OR
     

  • A piece of double-sided adhesive of sufficient size or 1-2 Command Strips.

Installation

  • Screw: Mark the location and drill a pilot hole or install a wall anchor. Attach the helmet hook to the wall with a screw. Push the screw cover into the screw hole until it snaps into place (it should be flush with the body of the hook when fully seated).
     

  • Adhesive: Cut an appropriately sized piece of double-sided adhesive mounting tape. Clean the back of the helmet hook and the wall where it will be installed. Attached one side of the piece of adhesive mounting tape to the back of the helmet hook. Attach the helmet hook to the wall with the other side of the double-sided adhesive mounting tape. Press firmly for 30 seconds and allow the recommended amount of adhesive "cure" time (if any) to elapse before using the hook. Press the screw hole cover into the screw hole until it pops into place (it should be flush with the body of the hook when fully seated).

Read more Show less

Print spec

Formats
3mfbgcode
Model files
2
Total size
881.3 KB
Largest file
604.1 KB

0 comments

See all