Bộ Giá Đỡ Thanh Đèn LED Cho AD5M

Slip-on brackets designed to hold light bars such as this: https://amzn.eu/d/0icAaw77

Uses the 20mm x 6mm rectangular magnets included with the lights. These are a press fit, but CA glue can be used to make the assembly permanent. These may be able to be snapped on over the PCB from the rear, but I recommend desoldering one of the two connectors and slipping them on from the end. Can be placed on any side of the printer by using the long cable that comes with the LEDs. The tolerances around the light bar have been deliberately left quite tight but can be opened up using a small emery board, file or sandpaper if required.