Skip to main content
F3D
Kẹp giữ dây điện bắt vít (Dành cho dây LS-FL 2x) 1

5 images

DIY

Kẹp giữ dây điện bắt vít (Dành cho dây LS-FL 2x)

By JayElectrics_161295

Downloads
7
Likes
7
Views
39

Files 6 1.7 MB

  • Cable_clamp_05_single_1784107016.stlSTL · 243.8 KB
  • Cable_clamp_05_double_1784107018.stlSTL · 313.7 KB
  • Cable_clamp_mini_05_single_1784107019.stlSTL · 249.9 KB
  • Cable_clamp_mini_05_double_1784107020.stlSTL · 320 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Just another cable clamp. I was struggling and also lazy to get these in the local hardware store and electrical supplies stores. So, I drew it up and printed plenty of them from PET-G due to the need for and flexibility. You can print them in minutes in any favorite color.

The clamps are to be fixed by 2.5x25 or 3x25 wood screws or longer. The hole is 3mm and after screwing, they are very hard break-off.

Printing Instructions:

  • Model files already face the clamping surface down (do not rotate!)

  • For print plate I recommend textured PEI plate (firm grip) or smooth plate

  • Print from PET-G, ABS or ASA

  • Infill: 50% or more

  • Perimeters: 3

  • No supports nor bridging neccessary

  • Brim is not needed if you have setup your 1st layer correctly and washed your plate with alcohol. Otherwise use brim 2-3mm but removing it on a couple of hundred pieces would be a pain...

If other dimensions are needed, let me know the cable size. If I am bored, I can draw-up some other clips round and oblong (UK) and possibly for fixing by hammer (using nails).

Read more Show less

Print spec

Formats
stl
Model files
6
Total size
1.7 MB
Largest file
320.3 KB

0 comments

See all