Skip to main content
F3D
Ống thép Gantry cho máy in Rat Rig V-Core 1

1 image

Máy In 3D

Ống thép Gantry cho máy in Rat Rig V-Core

By FBGDesign_302513

Downloads
4
Likes
1
Views
51

Files 1 726.3 KB

  • 18x18x2_new_1783852370.stlSTL · 726.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#411094
Category
Máy In 3D
Published

Description

It is intended that only the linear rail face is machined perfectly true. Machining all four faces would cause it to distort in difficult to manage ways. There are internal stresses in steel tube and if all four faces were machined this would cause warping of the tube as you machined each face that would cause warping of the other faces that would be hard to deal with.

It will work on all versions of V-Core 3 printers with both FFG and ALL other V-Core 3/3.1/3.2H,/34.5 Hybrid/FFG XY joiners 3D printed spacers.

Ideally machined from precision cold drawn 18 x 18 x 2mm steel tube. After machining top face is 1 mm thick. (This is taken into account in the planned mounting method with a printed spacer between the XY joiner and the opposite face.

The XY mounting holes are slotted to allow thermal breathing of the printer frame without causing binding on the gantry.

Calculated weight for the V-Core 300 length is 91 grams. Cost won't be cheap due to the machining but advantages will be a CTE that matches the linear rail and a much truer gantry tube than could be achieved by just cutting a piece of 'precision' tube to length and drilling holes in it.

The file uploaded is for a V-Core 300 sized printer. I will load files for 400 and 500 sized printers later.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
726.3 KB
Largest file
726.3 KB

0 comments

See all