Bento Mechanical Keyboard Macropad - Macropad Handwired Gọn Nhẹ

A little handwired macropad that you can take anywhere! Includes a rotary encoder slot perfect for volume control, page scrolling, and more.

You can find more information about QMK here.

[Handwiring]

Each switch must be connected to a different pin on the controller. I will be referring to a Pro Micro for this project. Please see the Pro Micro pinout. D7 will correspond to Pin 6 on the Pro Micro, B1 to Pin 15, and so on and so forth.

Each Cherry MX-style switch has two metal pins located on the bottom housing. These are the parts of the switch that you will be soldering.

I've made a wiring layout below:

Link

Please note that the rotary encoder is on the top right of the diagram. Follow the lines to see how to connect each switch to the controller (I didn't draw lines for the encoder as it was getting a tad bit messy).

[UPDATE]: Yes, two wires are shown connecting to TX0 if you also have RGB lights. Technically, you should be connecting the wire routed to the switches to GND instead. Only the RGB lights should connect to TX0. However if you wired per the diagram, it'll still work without any issue.

[Creating a keymap and flashing]

Set up your QMK Environment and install QMK Toolbox via this guide:

QMK Guide

Go into your 'qmk_firmware' folder and find the BDN9 keymaps at

qmk_firmware/keyboards/keebio/bdn9/keymaps

You may choose to edit the default keymap or copy the folder and create your own unique folder. Edit the keymap using your favorite text editing software (I like Sublime Text). Note that if you wired the macropad according to my wiring diagram, the only relevant keys to alter on the keymap file are Row1Column1 (for encoder), R2C1, R2C2, and all of Row 3. There will be 3 unused keys if using the BDN9 keymap. After setting up your preferred keymap, create your HEX file according to the guide and flash your Pro Micro!

Config files here.

Other parts you'll need to finish this build:

• 5x Cherry MX-style switches
• 5x MX-compatible keycaps
• 1x EC11 Rotary Encoder
• 1x Rotary Encoder knob
• 1x Pro Micro Controller or equivalent (Elite-C, Teensy, etc.)
• Lead wires for handwiring switches to controller
• Appropriate USB cable

Category: Electronics